On-Board Charger - Textron E-Z-GO Shuttle 2 2007 Manuel D'exploitation Et D'entretien

OPERATION AND SERVICE INFORMATION
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
Provide Protection From Elements
Do Not Block Louvered Airways
NEMA 15 - 5R Grounded AC Receptacle
110 - 120 VAC. Dedicated 15 AMP Circuit
Locations outside the US and Canada: Reference
appropriate local electrical code and charger manu-
facturer recommendations for AC power requirements
Fig. 2 Proper Charger Installation
Portable chargers are shipped with the vehicle. Prior to
vehicle or charger operation, chargers must be removed
and mounted on a platform or wall above the ground to
permit maximum air flow around and underneath the
charger. If the charger is operated in an outdoor location,
rain and sun protection must be provided (Ref Fig. 2 on
page 2). A dedicated circuit is required for the charger.
Refer to the charger manual for appropriate circuit pro-
tection. The charger may remain plugged in to the AC
outlet. To charge the vehicle, refer to the instruction
labels on the charger. Insert the polarized DC plug com-
pletely into the vehicle receptacle (Ref Fig. 3 on page 2).
Front of
Vehicle
Charger
Receptacle
Ref Crl 1
Fig. 3 Charger Receptacle Location
Page 2
The charger will automatically start a few seconds after
plug insertion. The charger will automatically stop when
batteries are fully charged and the DC plug can be
removed to permit use of the vehicle.
Looping the DC cord through the steering wheel when charg-
ing, serves as a good reminder to store the cord out of the way
when finished with charging. The DC plug can be damaged by
driving over or catching the cord on the vehicle when driving
away.
To reduce the possibility of a physical hazard
that could result in an electrical shock or elec-
trocution, be sure that the charger plug is not
damaged and is inserted into a grounded
receptacle.
The power (AC) cord is equipped with a
grounded plug, do not attempt to pull out, cut or
bend the ground post.
The charging (DC) cord is equipped with a polarized con-
nector which fits into a matching receptacle on the vehi-
cle.

On-board Charger

The on-board charger is located at the rear of the vehicle
and is mounted between the frame rails. An optional
retractable AC cord reel is also available. (Ref Fig. 4 on
page 3). The charger is wired directly to the batteries,
only requiring it be plugged into a dedicated 15 amp AC
outlet to be operational.
When charging cycle is complete, replace cord around
charger handle in area provided or in the retractable cord
reel (if equipped).
If vehicle is to be charged with a non E-Z-GO charger, refer to
the instructions supplied with the charger.
Owner's Manual and Service Guide