Monacor TVCCD-700COL Mode D'emploi page 35

** MOTION **
AREA
LEVEL —— —+————
TIME
OSD
RETURN
Use the keys and
Via the function "AREA
portant for the motion detection can be defined. After
pressing the key , a grid of 48 squares is laid on
the camera picture. The square in the top left corner
will flash. With the keys
square and with the keys
square. By shortly pressing the middle key , switch
between grey representation (area is of importance
for the motion detection) or transparent representa-
tion (area is ignored) of the selected (flashing)
square. When all areas have been adjusted, return
to the "MOTION" submenu by pressing the key
a longer time (> 2 s).
Via the parameter "LEVEL" adjust the sensitivity
of the motion detection with the keys
moving to the right, the sensitivity will be increased,
by moving to the left, the sensitivity will be reduced.
SET>
3sec
ON
to select the functions.
SET>" the areas im-
, select the preceding
, the following
and
The parameter "TIME" determines how long a
detected motion is shown. Use the keys
select the following values: "1 sec", "2 sec", "3 sec",
"5 sec", "10 sec", "30 sec", and "60 sec".
To show a detected motion, set the function
"OSD" to "ON" with the key
TION" will not be indicated in case of a detected mo-
tion until the OSD menu has completely been exited.
To return to the menu OPTION, select the func-
tion "RETURN" and confirm with the key .
8.9.9 CHROMA – basic adjustment of the colour representation
While for the white balance the colour representa-
tion is adapted to the light source (compare chapter
8.7), here a basic setting of the colours, e. g. for
matching the colour representation of a monitor, can
be made.
If the function "CHROMA" is selected, use the
key to call the following submenu:
for
R-Y GAIN
. By
B-Y GAIN
RETURN
or . However, "MO-
** CHROMA **
——— +————
————+— ——
GB
and to
35