Preparing Furniture Doors; Furniture Door Dimensions; Connecting The Appliance; Electrical Connection - Bosch BO Série Notice D'utilisation

Preparing furniture doors

Note:
When working on furniture doors, always observe
the following:
Select a furniture door thickness between at least 5/
■
8'' (16 mm) and 3/4'' (19 mm).
Always select a screw length which is shorter than the
■
thickness of the furniture door.
Always insert screws into the part of the furniture door
■
which is best able to handle the load.
Do not insert screws into fillings, etc.
■
Do not insert screws into filters, decorative strips, etc.
■
Protect the furniture door surfaces against damage
■
during installation.

Furniture door dimensions

Key
A Furniture door protrusion
B Lower edge of furniture door
The specified furniture door dimensions apply for a door
gap of / '' (4 mm).
5
32

Connecting the appliance

After installing the appliance, wait at least 8 hours until
starting up the appliance. During transportation the oil in
the compressor may have flowed into the refrigeration
system.
Before switching on the appliance for the first time, clean
the interior of the appliance (see chapter Cleaning the
appliance).

Electrical connection

,
WARNING:
Risk of electric shock!
Connect the appliance to a grounded, 3-phase
outlet only. Never remove the ground phase. Do
not use any adapters.Do not use any extension
leads.
,
WARNING:
Risk of electric shock!
Incorrect connection of the appliance may result
in death, fire or electric shock. Improper
connection of the protective conductor may result
in electric shock. If you are in doubt as to whether
the appliance has been properly grounded, have it
tested by a qualified electrician or Customer
Service technician.
,
WARNING:
Risk of electric shock!
If the length of the power cord is inadequate,
never use multiple outlets or extension leads.
Instead, please contact Customer Service for
alternatives.
This appliance must be connected to a permanently
installed outlet.
The outlet must be near the appliance and also freely
accessible following installation of the appliance.
The appliance complies with protection class I. Connect
it to a correctly installed outlet. Correct means: with a
protective conductor, 110 V – 120 V/60 Hz alternating
current. The outlet must be protected by a 10 A – 16 A
fuse.
The appliance comes with a UL registered 3-wire power
cord. The appliance requires a 3-pole outlet.
Please observe the following table with regard to this:
Appliance
Fridge-freezer
Check on the rating plate whether the indicated voltage
and current type match the values of your power supply.
The position of the rating plate can be found in the
chapter entitled Customer Service.
,
WARNING:
Never connect the appliance to electronic energy
saver plugs.
Our appliances can be used with mains and sine-
controlled inverters. Mains-controlled inverters are
used for photovoltaic systems which are
connected directly to the national grid. Sine-
controlled inverters must be used for isolated
applications (e.g. on ships or in mountain lodges)
which are not connected directly to the national
grid.
en-us
Maximum simultaneous
load
6 A
7