Dibo JMB-S Mode D'emploi page 99

Control Screen 2 (Temperature setting)
In this screen you can set the desired burner temperature. Move the control stick upwards (raise temperature) or
downwards (lower temperature) to set the desired temperature. Increase/decrease can be done in steps of 5 °C.
Turn off the burner immediately: Move the control stick quickly up / down.
Minimum value 0 °C - Maximum set point: depending on the factory setting.
Operate to the left: return to the main screen (at each other screen, same principle).
Operate to the right: navigate to the next operation menu (at each other screen, same principle).
At the top right, the current temperature is visualized and at the top left the burner indication.
Control Screen 3 (Engine speed setting - optional at JMB-S / WeedKiLLER-S)
In this screen you can set the desired engine speed. The basic setting at the start is set at 50%.
Pay attention: If the key contact is put into position "ON" , the engine speed is not adjustable.
Start the key contact by before the engine speed is adjustable!
Move the control stick upwards (increase speed) or downwards (lower speed) below to set the desired engine
speed. Increase/decrease in steps of 10%. Minimum value 0% - maximum value 100%.
At the top right, the current pressure is visualized.
Control Screen 4 (Lighting - optional)
In this screen you can set the lighting. Move the control stick upwards (work light on/off) or downwards (beacon
light on/off) to set the desired condition. Push the control stick to activate, push again to deactivate.
Control Screen 5 (Filling pump - optional)
In this screen you can turn on / off the filling pump.
Move the control stick upwards (turn on) or downwards (turn off).
JMB-S : REV A DiBO n.v. 99