Calibration Of The Expression Pedal; Settings Relative To [Rotary], [Exp] And [Hold] Pedals; Settings Of Audio Connections [Fx Send] And [Analog In] - Key B Organ Viscount Legend Solo Mode D'emploi

User Manual

6.5 CALIBRATION OF THE EXPRESSION PEDAL

By connecting an expression pedal to the [EXP] connector, it may be useful to calibrate it if the pedal's
operating range is not complete.
To calibrate the pedal, follow this procedure:
1) Position the pedal in the minimum position (pedal fully raised).
2) While holding down the [TRANSPOSE SELECT] button, press the F#4 key.
3) Place the pedal in the maximum position (pedal completely lowered).
4) While holding down the [TRANSPOSE SELECT] button, press the G#4 key.

6.6 SETTINGS RELATIVE TO [ROTARY], [EXP] AND [HOLD] PEDALS

[ROTARY] PEDAL
You can choose the mode of operation of the pedal connected to the [ROTARY] connector by which the speed
of the internal Rotary effect or the Rotary speaker connected to the [ROTARY SPEAKER] connector is selected.
By default, the operation is as described in the table at point 3 of par. 3.3, with the rotation speed selected
each time the pedal is pressed ("toggle" mode). By holding down [TRANSPOSE SELECT] and pressing the
D#5 key, the rotation speed can be changed only when the pedal is pressed while releasing the speed, the
speed back to the one selected by the lever ("momentary" mode). Holding down [TRANSPOSE SELECT] and
pressing the C#5 key returns the default operation.
[EXP] PEDAL
You can adjust the level of the audio signal when the expression pedal connected to the [EXP] connector is at
the minimum position. By default, the signal level with the pedal at minimum is attenuated but not muted. If you
want the signal to be completely muted, press and hold [TRANSPOSE SELECT] while pressing the G3 key.
By holding down [TRANSPOSE SELECT] and pressing the A3 key, the minimum level is reset to the default
value.
[HOLD] PEDAL
You can choose how to operate the footswitch pedal connected to the [HOLD] connector on the rear panel
(see section 3 of section 3.2). After switching on, the pedal acts on the notes produced by the internal sound
generation and its MIDI message (Control Change Sustain n. 64) is sent to the [MIDI OUT 1] and [MIDI OUT 2]
ports. By pressing the [TRANSPOSE SELECT] button and the C5 key at the same time, it only transmits MIDI
message (Control Change Sustain n. 64) without the pedal acting on internal sound generation.
Pressing [TRANSPOSE SELECT] and the B4 key, the pedal returns to normal operating mode.

6.7 SETTINGS OF AUDIO CONNECTIONS [FX SEND] AND [ANALOG IN]

EFFECT SEND [FX SEND]
By default the effect send of the [FX SEND] connector transmits the general audio signal of the instrument. It is
possible to send on this output only the signal coming from the upper manual and not that of the lower manual
and pedalboard if you do not want to process it with an external effects processor. To do so, while holding
down [TRANSPOSE SELECT], press the D#4 key of the upper manual. To return to the default condition, while
holding down [TRANSPOSE SELECT], press the C#4 key of the upper manual.
AUDIO INPUT [ANALOG IN]
By default the signal coming from the [ANALOG IN] connector, before being transmitted back to the [LEFT],
[RIGHT], [ROTARY SPEAKER] and [PHONES] outputs, is sent to the effects chain (Reverb, Drive, Rotary and
Equalizer). If you do not want this signal to be processed by such effects, while holding down the
EN - 20