Key B Organ Viscount Legend Solo Mode D'emploi page 37

- [FX SEND]: line output (output impedance: 680 Ω, signal level: 9 Vpp), it only transmits the drawbars'
signal (and Vibrato or Chorus if enabled) so as to process the signal with external effects. The signal
from this output is not controlled by the potentiometer [VOLUME] (see point 4 of par. 3.1).
- [FX RETURN]: line input (input impedance: 32,4 KΩ, maximum input signal level: 11,2 Vpp), it receives
the signal from an external effect processor connected to the [FX SEND] port (se previous point). This
signal is then modified by the equalizer and the internal effects Reverb, Drive and Rotary of the
Solo
, then sent to the outputs [LEFT], [RIGHT], [ROTARY SPEAKER] and [PHONES] (also on the front).
NB
- When plugging a jack to the [FX RETURN] connector, the internal sound generation is disconnected from the
[LEFT], [RIGHT], [ROTARY SPEAKER] and [PHONES] outputs; the signal sent to these outputs is that of [FX
RETURN].
- It is possible to select whether to send the upper and lower manual or only the upper manual to the [FX SEND]
output. For more information see par. 6.7.
- [ANALOG IN]: line input for signal from an external audio device. This signal is then modified by the
equalizer and the internal effects Reverb, Drive and Rotary of the
[LEFT], [RIGHT], [ROTARY SPEAKER] and [PHONES].
NB
If you do not want to process the signal present at the [ANALOG IN] connector with the internal effects and the
equalizer, follow the instructions in par. 6.7.
- [INPUT GAIN] trimmer: adjust the gain of the signal from the input connector [ANALOG IN] within a
range from -∞ (input impedance: 7,5 KΩ, signal level: 0 V) to + 16dB (input impedance: 17,5 KΩ, signal
level 400 mVpp).
3. [PEDALS CONTROLS] connectors.
- [EXP]: connect here the expression pedal's cable, for continuous volume control during the
performance. Use with:
• Expression pedal of the optional Viscount pedalboard (EXPRESSION cable).
• Optional Viscount expression pedal.
• Any RTS expression pedal.
- [ROTARY]: connect here the cable from the pedal you wish to use to control the speed of the internal
Rotary effect. It can also be used to control the speed of an external rotating speaker connected to the
[ROTARY SPEAKER] port (see point 1 of this paragraph).Use with:
•
Control lever on the expression pedal of the optional Viscount pedalboard (ROTARY cable).
•
Optional Viscount switch pedal.
•
Any switch type pedal.
The operation of the pedal connected to this connector depends on the Rotary speed selected with the
panel buttons (see section 12 of section 3.1), as described in the following table:
Rotary Speed
BRAKE
SLOW
FAST
NB
When switching on, the instrument automatically detects the polarity of the switch pedals connected to the
-
[ROTARY] and [HOLD] connectors. Do not hold down the pedals when turning the power on, to avoid reversing
the operation of the pedals.
The operation of the pedals connected to the [EXP] and [ROTARY] connectors can be customized. For more
-
information see par. 6.6.
Pedal function
BRAKE / FAST
SLOW / FAST
none
EN - 9
Legend Solo , then sent to the outputs
User Manual
Legend