Single, Split And Double Modes - Key B Organ Viscount Legend Solo Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.5 SINGLE, SPLIT AND DOUBLE MODES

Legend Solo
You can use the
SINGLE
In this mode, the set of drawbars selected using the
[SET A/SET B] button (see section 5 of par. 3.1) will
sound throughout the keyboard extension. The active
section is the Upper, so you can play the percussion as
well. Having two sets of Drawbars available, you can set
them up with two different sounds so that you can recall them in real time while playing. Lower presets are not
selectable.
SPLIT
This mode simulates the two Upper and Lower manuals
of an organ with the single
keyboard is divided into two sections, Upper and Lower,
respectively to the right and to the left of a splitting key
Split Point
.
called
To select this mode, press the [SPLIT/DOUBLE] button,
the LED lights up in blue. Press the button again to return to
Split
In
mode the drawbars Set A is assigned to the Upper section while the Set B is assigned to the Lower
section.
With the factory settings, the
the [SPLIT/DOUBLE] button and pressing the desired key note.
DOUBLE
In this mode, you can simulate an organ with two full
Split
manuals (unlike
mode where the two manuals are
Legend Solo
played with the single
an external keyboard whose MIDI data port is to be
connected to the connector [MIDI IN] of the
Solo
.
To
select
this
mode,
[TRANSPOSE
SELECT]
[SPLIT/DOUBLE] button, whose LED lights up in red.
Press the button again to return to
In this mode, the Upper section is assigned to the
Legend Solo
keyboard of the
A control the sound of the Upper section. The Lower section instead plays with MIDI data received from the
[MIDI IN] connector, transmitted by the external keyboard that simulates the lower manual of the organ.
Set B drawbars control the sound of the Lower section.
NOTES
-
In Single mode, you can play the Lower section with an external device (keyboard, sequencer, computer)
connected to the [MIDI IN] port, but you can't control the sound with the drawbars of the Legend Solo. The Lower
section sound is initially adjusted based on the position of the drawbars of Set B when powering up the
instrument. To change the sound of the Lower section in real time, see the fourth note here.
In Split mode, you can also play the Lower section with an external device (keyboard, sequencer, computer)
-
connected to the [MIDI IN] port on MIDI channel 2 only.
In Double mode, the notes received from the [MIDI IN] port are transposed according to the transposition
-
eventually set and are retransmitted to the [MIDI OUT] port so that they can also be played with external sound
generators.
In Single, Split and Double mode, you can control the Lower section drawbars with an external device that can
-
transmit programmable MIDI control messages (eg with sliders or potentiometers).
All information about the MIDI channels and MIDI messages received by the Legend Solo are listed in the "MIDI
-
Informations" section.
in three operating modes:
Legend Solo
keyboard. The
Split Point
is associated with the B2 key, but it can be changed by holding down
keyboard) by using
Legend
while
holding
down
button,
press
Single
mode.
, simulating the upper manual of the two-manuals organ, and the drawbars of Set
EN - 15
Single
Split
Double
,
and
Single
mode.
the
MIDI OUT
the
Lower
User Manual
.
Upper
Upper
MIDI IN

Publicité

Table des Matières
loading

Table des Matières