Key B Organ Viscount Legend Solo Mode D'emploi page 34

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

User Manual
17. [LOWER PRESETS] buttons.
Buttons for selecting the Lower section Presets. The led indicates which Preset is currently selected.
18. [BASS] potentiometer.
Regulates the gain of +12 dB (with the potentiometer turned to the right) or attenuation of -12 dB (with
potentiometer turned to the left) of the low frequencies centred at 125 Hz.
19. [MIDDLE] potentiometer.
Regulates the gain of +12 dB (potentiometer turned to the right) or attenuation of -12 dB (potentiometer to
the left) of the mid-frequency band, centred at 800 Hz.
20. [TREBLE] potentiometer.
Regulates the gain of +12 dB (potentiometer turned to the right) or attenuation of -12 dB (potentiometer to
the left) of high frequencies, centred at 4 KHz.
NB
The [TREBLE] potentiometer can alternatively be used as the TONE CONTROL knob of the AO-28 preamplifier of the
electromechanical organs. For more information see par. 6.3.
21. [PERCUSSION VOLUME] potentiometer.
Adjusts the maximum volume of the percussion.
22. [PERCUSSION DECAY] potentiometer.
Adjusts the maximum decay time of the percussion when the key is pressed.
23. [ROTARY CLASSIC/ROCK] button.
Select the listening mode of the rotating speaker. The CLASSIC type simulates the speaker as it is actually
perceived by the musician. In this mode, the led turns off. The ROCK mode simulates the sound of a
rotating diffuser as recorded by a microphone. In this mode, the led turns on.
Pressing the [TRANSPOSE SELECT] and [ROTARY CLASSIC/ROCK] buttons simultaneously, you can
exclude the Rotary effect from the [LEFT], [RIGHT], and [PHONES] outputs. When disabled, the led of the
[ROTARY CLASSIC/ROCK] button is red. Press the same buttons to restore the effect.
For more information on the Rotary effect, see par. 5.4.
24. [SPLIT/DOUBLE] button.
Select the operating mode of the instrument. led off indicates
By pressing the button, the led lights up in blue and
Single
return to
mode.
Holding down the [TRANSPOSE SELECT] button and [SPLIT/DOUBLE], the led lights up red and
mode is activated. Press [SPLIT/DOUBLE] again to return to
For more information on the operating mode of the instrument, see par. 4.5.
25. [OCTAVE UP] button.
Split
In
mode, when the led is on you can play the Lower section with a transposition of one octave
upward.
18
19 20 21 22
17
23
24 25 26 27 28
EN - 6
29 30 31 32
Single
mode.
Split
mode is activated. Press the button again to
Single
mode.
Double

Publicité

Table des Matières
loading

Table des Matières