Tone Control; Memphis Style" Mode - Key B Organ Viscount Legend Solo Mode D'emploi

The following table shows the MIDI channels assigned to the connectors described above:
Section
Upper
Lower
Pedalboard
[USB TO HOST] PORT OPERATION
The [USB TO HOST] connector on the rear panel can be used to exchange the MIDI data transmitted and
Legend Solo
received by
As described previously,
HOST] port, you can select how to transmit MIDI data.
While holding down [TRANSPOSE SELECT] and pressing the C#1 key, the [USB TO HOST] port operates like
[OUT 1].
While holding down [TRANSPOSE SELECT] and pressing the D#1 key, the [USB TO HOST] port works like
[OUT 2].
TRANSMISSION OF THE CONTROL CHANGE 11 WITH THE PEDAL CONNECTED TO
THE [EXPR.] CONNECTOR
Most musical instruments with a MIDI interface transmit the MIDI Control Change message n. 11 when acting
on the expression pedal connected, so as to control in real time and in a continuous manner the volume of an
external sound generator. You can choose whether to transmit (default condition) or not to the [MIDI OUT] and
[USB TO HOST] (when acting as OUT 1) ports this MIDI data, so you can adjust the volume of both
instruments or just the volume of the
If you hold down [TRANSPOSE SELECT] and press the G#4 key, CC 11 is not transmitted.
By holding down [TRANSPOSE SELECT] and pressing the A#4 key, CC 11 is transmitted.
MIDI DUMP FUNCTION
If you need to register the current instrument configuration (drawbars, buttons, potentiometers and pedals) on
an external sequencer, after you start recording hold down the [TRANSPOSE SELECT] button and press the
C3 key on the keyboard. Use the same button and key combination if you want to reset the instrument with the
current panel configuration after receiving a different setting from the sequencer at playback time.

6.3 TONE CONTROL

In the original electromechanical organs equipped with the AO-28 preamplifier, there is a TONE CONTROL
knob that allows you to greatly modify the frequency response by attenuating the high frequencies.
Legend Solo
allows you to simulate this control with the [TREBLE] potentiometer.
To do so, while holding down [TRANSPOSE SELECT], press the F4 key. To restore normal use of the
potentiometer as a [TREBLE] control, while holding down [TRANSPOSE SELECT], press the E4 key.

6.4 "MEMPHIS STYLE" MODE

It is called "Memphis style" the mode of using the rotating speakers unplugging the motors on the lower rotor,
so that only the upper rotor continues to spin. This mode allows you to have a solid bass sound and the treble
that continue to be modulated.
To activate the "Memphis style" mode, while holding down [TRANSPOSE SELECT], press the A2 key of the
upper manual.
To deactivate the "Memphis style" mode, while holding down [TRANSPOSE SELECT], press the G#2 key in the
upper manual.
[IN] [PEDALS KEYB ONLY]
1
2
3
with external devices (personal computers, expander).
Legend Solo
can transmit MIDI data in different ways. With regard to the [USB TO
Legend Solo .
Legend Solo
allows you to simulate this mode with the internal Rotary effect.
---
---
1 - 16
EN - 19
User Manual
[OUT1] - [OUT2]
1
2
3