Rear Panel - Key B Organ Viscount Legend Solo Mode D'emploi

User Manual

3.2 REAR PANEL

1 1
1. [ROTARY SPEAKER] connector.
11-pin connector for the connection of an external speaker. This output transmits the signal generated by
drawbars, equalizer, Vibrato or Chorus effects, Reverb when set as PRE (see par. 5.2) and Drive.
Furthermore, through this connector, using the rotating speaker controls (see point 12 of par.3.1) you can
select the speed (FAST or SLOW) of the speakers' rotation, or stop the engine (Brake mode).
2. [AUDIO] jack connectors.
- [PHONES]: stereo output for connecting a set of headphones. The port sends out the instrument's
general signal.
- [LEFT] and [RIGHT]: line outputs; use to connect the instrument to external audio devices (amplified
speakers, mixers, amplifiers); they transmit the instrument's general signal.
When used with stereo systems, connect the [LEFT] output to the left channel and the [RIGHT] output to
the right channel. When using a monophonic system, any of the two outputs ([LEFT] or [RIGHT]) can be
connected indistinctly; however, doing so will make it impossible to hear the stereophonic effect
generated by the Rotary simulation: it is only possible to hear the connected audio channel. Therefore
this is not recommended.
- [PEDALS]: line output dedicated to the signal of pedalboard drawbars. To enable this output,
simultaneously press the [TRANSPOSE SELECT] and [PEDALS TO LOWER] buttons. Thus, the pedal
sound is also excluded from the [LEFT], [RIGHT], and [PHONES] outputs. When output is enabled, the
[PEDALS TO LOWER] led is red. Press the same buttons again to reset the pedal sound to the other
audio outputs and turn off the [PEDALS] output.
WARNINGS ON THE USE OF SPEAKERS
-
The [ROTARY SPEAKER] on Legend / Legend Live should only be connected
to a rotating speaker equipped with a cable with the following pinout:
1: Audio +
4: Audio GND
5 - 6: common of speed switch
7: Fast
8: Slow
2 - 3 - 9 - 10 - 11: N.C.
If the connector has a diferent setup, an adapter should be used.
-
Always perform the connection while both instrument and speakers are
switched off. Then first switch on the instrument and later the speakers.
-
The use of balanced cables is recommended for connecting the [LEFT], [RIGHT], [PEDALS] and [FX SEND]
outputs.
2 3 3
EN - 8
4 4 5 5 6 6
Pin 9
Pin 10
Pin 11
Pin 1
Pin 2
Pin 3
7 7
Pin 8
Pin 7
Pin 6
Pin 5
Pin 4