Notes On Safety; Symbols And Icons; Symbols On The Device - Parkside PWS 125 D3 Traduction Des Instructions D'origine

Safety class .....................................
Protection category ........................ IP 20
Sound pressure level
(L ) ................... 93,2 dB(A); K
pA
Sound power level (L
measured ........ 104,3 dB(A); K
guaranteed ......................... 107 dB(A)
Vibration (a ) .... 12,104 m/s
h
The vibration values represent maximum
values which have been determined with
the supplied blade. The actual vibration
values may vary depending on the used
accessories.
The vibration values are still affected by
the handling for the user's.
Cutting disc (included):
Idling speed n .............. max.12200 min
0
Disc speed ........................max. 80 m/s*
Outer diameter ................... Ø 125 mm
Bore hole ........................ Ø 22,23 mm
Thickness ................................... 3 mm
*
The grinding disc must keep a rotational
speed of 80 m/s.
Levels of noise and vibration were determi-
ned according to the norms and regulati-
ons in the declaration of conformity.
The vibration emission value has been
measured according to a standardised
testing method and may be used for com-
parison with another electric tool.
The indicated vibration emission value
may also be used for an introductory as-
sessment of the exposure.
Warning:
The vibration emission value whilst
actually using the electrical tool
may vary from the given values in-
dependently of the type and way in
which the electric tool is used.
= 3 dB
pA
)
WA
= 3 dB
WA
; K= 1,5m/s
2
II Safety measures for the protection
of the operator are to be determined
that are based on an estimate of the
actual exposure under the real ope-
rating conditions (for this, all parts of
the operating cycle are to be taken
into account, for example, times in
which the electric tool is turned off,
2
and those during which it is turned
on but running without a load).

Notes on safety

Caution! When using power tools,
observe the following basic safety
measures for the prevention of electric
shocks and the risk of injury and fire.
Please read all these instructions
before using this electric tool and
-1
please keep the safety instructions.

Symbols and icons

Symbols on the device:

Warning!
Risk of injury from the rotating tool!
Keep hands away.
Warning! Electric shock hazard.
Always unplug the device before
working on it.
Read the manual!
Wear ear protection
Wear eye protection
Wear breathing protection
Risk of cuts! Wear cut-resistant
gloves.
GB IE
2 7