Switching On And Off; Maintenance And Cleaning - Parkside PDSS 16 A1 Traduction Des Instructions D'origine

Switching on and off
Switching on:
♦ First, press the trigger lock
down to switch the tool on.
Switching off:
♦ Release the trigger
♦ When you have finished working, disconnect the tool from the
compressed air source.

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the tool from the compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous substances that
may have accumulated on the tool (due to working processes).
Avoid all skin contact with these substances. If the skin comes
into contact with hazardous dusts, this can lead to severe der-
matitis. If dust is produced or swirled up during maintenance, it
can be inhaled.
NOTE
► To ensure correct functioning and a long service life for the
tool, pay attention to the following points:
■ Sufficient and continuous oil lubrication is highly important for
optimum functioning.
■ Check the speed and vibration levels after each use.
■ Check the idle speed regularly and after any maintenance is
performed: use a rev counter and perform the measurement with-
out any clamped tools. At a residual pressure of 6.3 bar, the idle
speed may not be exceeded under any circumstances.
│ GB │ IE │ NI
■ 20
forwards and then the trigger
.
PDSS 16 A1