Using The Tft Monitor; Open/Close Tft Monitor - Audiovox VME 9114 TS Instructions

USING THE TFT MONITOR

Open/Close TFT Monitor

Open TFT Monitor
Press the OPEN button (1) on the front panel to activate the mechanism that moves the display panel into the viewing position.
Close TFT Monitor
Press the OPEN button (1) on the front panel to load the display panel back into the compartment.
TFT Monitor Auto Open
If "TFT Auto Open" is "on" when the unit is turned on, the monitor automatically moves to the viewing position.
If "TFT Auto Open" is "off" when the unit is turned on, press the OPEN button (1)to move the monitor into the viewing position.
If "TFT Auto Open" is set to "Manual", the TFT will not close when the key is turned off.
Monitor Tilt Angle Adjustment
A known characteristic of LCD panels is the quality of the display in relationship to the viewing angle. The monitor angle can be adjusted for optimum
viewing using one of the following methods:
Step by Step Angle Adjustment
Press the ( 4 ) to adjust the tilt angle of the screen one step at a time.
Press the TILT button (5) on the unit. While the blue tilt icon is flashing, turn the rotary encoder to adjust the screen angle.
Aspect Ratio
Press the WIDE button (2) on the monitor to adjust the aspect ratio as follows:
Playing Source
Radio
Disc
USB
AUX
CAMERA
FULL
The entire screen is extended horizontally to the aspect ratio of
16 to 9. The extension ratio is the same at any point.
NORMAL
The conventional display image has a 4 to 3 ratio of horizontal to vertical,
leaving a blank area on the right and left sides of the display.
STANDBY
Screen becomes black. Touch screen to resume.
Video Output Modes
RGB-Modus
RGB-Modus
CVBS-Modus
CVBS-Modus
CVBS-Modus
Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button control panel.
2. Select Item to Set:
Press the PIC button (2) on the control panel to select
"BRIGHT" or "CONTRAST".
3. Turn the rotary encoder on the control panel.
4. Exit Picture Quality Setting Mode:
Press the button PIC (2) on the monitor.
* CVBS - Composite Video Baseband Signal
10