Volume Adjustment; Audible Beep Confirmation; Using The Tft Monitor; Resetting The System - Audiovox VXE 3010 Mode D'emploi

Mute
Press the volume knob on the front panel or press the [MUTE] Button on the remote control to
mute the volume from the unit.

Volume Adjustment

Volume Increase/Decrease
To increase or decrease the volume level, turn the rotary encoder on the front panel. When the
volume level reaches "0" or "50", a beep sounds, indicating that the adjustment limit has been
reached. The TFT screen displays the volume level for 3 seconds.

Audible Beep Confirmation

An audible beep tone confirms each function selection. The beep tone can be disabled through the
Setup menu.

Using the TFT Monitor

Open / Close monitor
Press the [OPEN] Button on the front panel or remote control to open or close the display panel.
NOTE: Never manualy open or close the display panel.
Change the monitor tilt angle
Due to the inherent character of LCD, you will get different vision impressions when you watch it
from different angles. The display angle of this unit can be changed; hence you can select the best
angle where you can get the best vision impression. Press and hold the [OPEN] Button to enter
display angle setting mode, and rotate the knob to adjust.
NOTE: Never manually tilt the display panel.

Resetting the System

Soft Reset
To correct a system halt or other illegal operation, use the tip of a pen to press and release the
reset button located just below the front panel control knob.
[RESET] Button
Figure 5. System Reset Button
Hard Reset
Touch the System Reset Icon on the Third Settings Screen.
After a system reset,the unit restores all factory default settings.
NOTE: If the unit is reset while a DVD is playing, the unit will return to Main Menu once the
reset is complete.
59