Troubleshooting; Tft Monitor - Audiovox VXE 3010 Mode D'emploi

TROUBLESHOOTING

Problem
General
Unit will not power on
Remote control does
not work
No/low audio output
Poor sound quality or
distortion
Unit resets itself when
engine is off

TFT Monitor

No image
Flashing image or
interference appears on
screen
Prolonged image or
improper height/width
ratio display
Cause
Radio Fuse blown.
Car battery fuse blown.
Illegal operation.
Battery depleted
Battery installed incorrectly.
Improper audio output connection.
Volume set too low.
Improper "MUTE" connection.
Speakers damaged.
Heavily biased volume balance.
Speaker wiring is in contact with metal
part of car.
Pirated disc is in use.
Speaker power rating not compatible
with unit.
Speaker is shorted.
Incorrect connection between ACC
and positive battery wire.
Incorrect connection to parking brake
wire.
Parking brake is not engaged.
DVD is not compatible with current TV
system settings.
Improper video signal connections.
Improper aspect ratio setup.
Corrective Action
Install a new fuse with the
correct rating.
Install a new fuse with the
correct rating.
Press the RESET button
located over the rotary
encoder on the front panel.
Change the battery
Install the battery correctly
Check wiring and correct.
Increase volume level.
Review wiring diagram and
check "MUTE" connection.
Replace speakers.
Adjust the channel balance
to the center position.
Insulate all speaker wiring
connections.
Use original copy.
Connect proper speakers.
Check speaker contact.
Check wiring and correct.
Check wiring and correct..
Stop vehicle in safe place
and apply parking brake.
Change setup to
accommodate disc.
Check wiring and correct.
Use correct aspect ratio
setting.
85