Publicité
Les langues disponibles
Les langues disponibles
29
reached. Information on the programming of features is contained in the Section
"Setting the output address and features (programming)" on page 12.
E
Connecting switching devices to the feedback inputs of the LS100
When using double-coil point drives with auto-shutoff (no. 1 in the illustration
below), connection to the signal inputs of the LS100 is very easy: connect
terminals + and - to the neighbouring terminal RM. See the illustration below.
If your drive has separate feedback contacts (no. 2 in the illustration below),
connect these contacts to the terminals "RM" and "C".
Refer to the operating manual supplied with each device for information on how to
read out the point setting at the manual control LH100 or any other device.
2
1
+
+
+
+
C
C
C
C
RM
RM
RM
RM
RM
RM
RM
RM
1
2
3
4
Lenz Elektronik GmbH D 35398 Giessen
J K R
S
Figure 6
Publicité
