Abicor Binzel xFUME FLEX Mode D'emploi page 33

xFUME FLEX
Without
Without
Tab. 6 Mounting the extraction arm
BAL.0733.0 • 2021-01-11
3 Mount the extraction rod on the mounting tube with
two M8 hexagon bolts, washers and hexagon nuts.
4 Connect the electric cable that extends from
the extraction rod to the extraction system
(plug-in connection).
5 Pull the extraction hose over the handle in the
direction shown.
6 Fold the rubber sleeve on the extraction system over the
extraction hose and fix with the gripping clamp.
7 Place the connecting tube in position and pull the rubber
sleeve over the connecting tube until it covers the metal
flange. The rubber sleeve must be on the plastic tube so
that it subsequently creates a seal with the metal flange.
8 Fold the rubber sleeve down halfway, so that the metal
flange is protruding at the top.
6 Commissioning
EN - 11