Maintenance; Replacing The Fuse; Troubleshooting - Eaton xChargeIn A Serie Manuel D'installation

xChargeIn
10

Maintenance

10.1

Replacing the fuse

F1
To replace the fuse, proceed as follows:
1) Switch off the supply voltage of the charging station.
2) Remove the housing cover, the connection panel cover, and the terminal
3) Using a screwdriver, press into the opening of the fuse holder.
4) Screw the fuse holder counterclockwise until it springs forward automati-
5) Replace the fuse.
6) Press the fuse holder in and tighten clockwise.
7) Mount the housing covers on the charging station again.
The fuse has now been replaced.
10.2

Troubleshooting

Further information (e.g. operating and configuration instructions) and con-
tact details are available on the Eaton website:
http://www.eaton.com/evc
Installation manual V1.01
© EATON
Fuse Current / Voltage
6.3 A / 250 V
cover.
If there is a seal on the connection panel cover or terminal cover, it may
only be removed by an authorized person! After changing the fuse, the
seal must be replaced.
cally by the spring.
Type
Delay with high breaking
capacity (>1500A) (T) (H)
Maintenance
Dimensions
5 x 20 mm fuse
49