Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Mounting and installation instructions
4) Turn the hanger bolts into the hole / anchors until the thread still pro-
5) Pull the cable through the prepared openings on the charging station.
6) 4 of the supplied washers can be used to compensate for any uneven-
7) Position the charging station on the wall and secure it with the 4 wash-
The charging station is now mounted on the wall and ready for cabling.
28
1
... Washer for adjusting
3
... Washer for nut
5
... Hanger bolt
trudes approx. 20 mm
Pay attention to leak tightness!
ness and to ensure proper water flow behind the device: If necessary,
place the washers
1
ers 3
and nuts
4
to the hanger bolts
2
... Rear wall of the charging station
4
... Nut
x
... 20 mm
x
.
on the hanger bolts.
5
.
xChargeIn
Installation manual V1.01
© EATON
Publicité
Chapitres
Table des Matières
Dépannage
