Mounting The Charging Station - Eaton xChargeIn A Serie Manuel D'installation

Mounting and installation instructions
6.4

Mounting the charging station

The charging station must be prepared for this before mounting. To do this,
proceed as follows:
1) Unscrew the two screws on the bottom side of the housing cover.
2) Lift the housing cover at bottom max. 1 cm
3) Loosen the four screws of the connection panel cover and remove the
4) Loosen the two screws of the terminal cover and remove the terminal
5) Place the charging station on a stable surface.
26
connection panel cover upwards.
cover upwards.
xChargeIn
1 and then push upwards 2.
Installation manual V1.01
© EATON