Mounting And Installation Instructions - Eaton xChargeIn A Serie Manuel D'installation

Mounting and installation instructions

6 Mounting and installation instructions
Depending on the scope of delivery, a mounting set for wall mounting is
available. The mounting set is suitable for cement, brick and wood (without
anchors). For other surfaces, a suitable method of installation must be se-
lected.
Depending on the device model or for special materials, the installation ma-
terials must be provided by the customer. Proper installation is absolutely
necessary and lies outside of the scope of responsibility of the manufacturer.
WARNING!
Risk of electric shock and fire hazard!
For installation on hollow walls, at least 2 mounting screws must be secured
to a support element of the wall. Special hollow-wall anchors must be used
for the other mounting screws. It is particularly important to ensure sufficient
load-bearing capacity of the sub-construction.
Caution
Property damage due to dampness and moisture!
● The installation and commissioning of the charging station must take
● Only a vertical installation of the charging station is permitted. The
● Do not subject the charging station to high humidity for a longer period of
● If a cold charging station is brought into a significantly warmer environ-
● Always equip the charging station completely and properly with the sup-
22
place in a suitable environment. The charging station must be protected
against rain, snow and dirt during the process. For installation outdoors,
the connection panel cover is not permitted to be opened in rain, wind or
snow weather conditions.
charging station must be mounted with the supplied washers at a 90°
angle to the mounting surface - no inclination is allowed, otherwise water
drainage will not be possible and damage to the device will result (see il-
lustration below).
time.
ment (e.g. after a longer transport in a cold environment), condensation
moisture may form in the device.
Before connecting the charging station to the power supply, you must
wait until the temperature of the charging station is the same as the
room temperature and the moisture has evaporated again.
plied cable glands. Unused cable insertion openings must be screwed
closed with blind plugs to ensure the necessary leak tightness.
xChargeIn
Installation manual V1.01
© EATON