Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
xChargeIn
7
Connections and wiring
7.1
Connection overview
The following illustration shows a connection overview with the covers open.
Fig. 7-15: Connection overview
DSW1
Shd
USB
WARNING!
Risk of electric shock and fire hazard!
● For terminals X1-X4 (Ethernet connections as well as terminals for en-
● The connection panel is never permitted to be left open unattended. Be-
Installation manual V1.01
© EATON
F1
... Fuse holder
2
... Mains connection phase conduc-
tor 2
N
... Mains connection neutral conductor
... DIP switch
T1
... Service button
X1
... Enable input
... Shield clamp (mass for ETH)
X4
... Ethernet1 connection (LSA+® ter-
minals)
... USB interface
abe input and switch contact output), only voltages and circuits are per-
mitted to be connected which have a safe separation to dangerous volt-
ages (for example sufficient insulation).
Supply the terminal for the switch contact output (X2) exclusively from
voltage sources which have a protective extra-low voltage.
fore leaving the charging station, the connection panel cover must be
mounted.
Connections and wiring
1
... Mains connection phase conduc-
tor 1
3
... Mains connection phase conduc-
tor 3
PE
... Mains connection earthing conduc-
tor
DSW2
... DIP switch
LED
... Status LED
X2
... Switch contact output
X3
... Ethernet2 connection (RJ45)
SIM
... SIM card slot (optional)
29
Publicité
Chapitres
Table des Matières
Dépannage
