Connecting The Cable - Eaton xChargeIn A Serie Manuel D'installation

Connections and wiring
Terminal data
Inflexible cable
Cat 5e / Cat6 STP
Cat 6 STP
Flexible cable
Cat 5e / Cat 6 STP
Preparing the connection cable
To prepare the connection cable, proceed as follows:
1) Strip the connection cable about 6 cm.
2) Knock back approx. 1 cm of shielding all over and wrap with conductive

Connecting the cable

To connect the cable, proceed as follows:
1) Fix the connecting cable at the point of the wrapped-around shielding
2) Tighten the shield clamp.
3) Clamp the wires to the terminal block [ETH] using an insertion tool.
38
Category
textile adhesive tape.
braid in the shield clamp [K].
Wire diameter
0.36 mm (AWG 27)
0.4 – 0.64 mm
(AWG 26 – AWG 22)
0.51 – 0.81 mm
(AWG 24 – AWG 20)
7 x 0.2 mm
(AWG 24)
xChargeIn
Insulation diameter
0.7 – 0.75 mm
0.7 – 1.4 mm
1.0 – 1,4 mm
1.1 – 1.4 mm
Installation manual V1.01
© EATON