Errors: Causes And Solutions - Tecno-gaz EKSTRA PLUS PT002TTM Mode D'emploi

LUBRICATION CYCLE:
The lubrication cycle is performed according to the following steps:
SCREEN B2-1
7.7

Errors: causes and solutions

Situations that may occur prior to operation and prevent the cycle from being launched:
EMPTY DETERGENT TANK
FLASHES
SCREEN E101
FULL DETERGENT TANK
FLASHES
SCREEN E102
EMPTY OIL TANK
FLASHES
SCREEN E103
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
PHASE 1 BLEED
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
FINISHED CYCLE
OK
OK
OK
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
PHASE 2 LUBRICATION
SCREEN B2-2
DD-MM-AA hh-mm
TYPE OF CYCLE:
LUBRICATION
PHASE 3 BLEED
CAUSES:
This is displayed when the user presses
START and the level of detergent is insufficient
to perform a cycle.
SOLUTIONS:
Pour detergent into the tank.
CAUSES:
This is displayed when the level reaches the
maximum limit while
accompanied by a beep.
SOLUTIONS:
Suspend the filling operations and put the cap
on the filler inlet of the tank.
CAUSES:
This is displayed when the user presses
START and the level of oil is insufficient to
perform a cycle.
SOLUTIONS:
Pour oil into the tank.
ENGLISH
filling the tank,
25