Display During The Cycle - Tecno-gaz EKSTRA PLUS PT002TTM Mode D'emploi

ENGLISH
7.6

Display during the cycle

As previously mentioned, after performing the following steps:
a)
Inserting the instruments
b)
Closing the door
c)
Selecting the stations and type of cycle
The cycle is launched by pressing the START button.
Since the treatment, as previously shown in Fig.20 and Fig.22, is applied to individual
channel types

it is possible to inhibit the treatment of water/spray channels, for the treatment of tools
that do not have connections for water/spray cooling channels integrated in the quick
connection:
DO YOU WANT TO EXCLUDE
THE TREATMENT FOR
WATER AND SPRAY PIPES
J
COMPLETE / EKSTRA CYCLE:
The cycle is performed according to the sequence of the steps listed below and shown on the
display.
DD-MM-AA hh-mm
TYPE OF CYCLE
DD-MM-AA hh-mm
COMPLETE
PHASE 1 BLEED
SCREEN B1-1
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
FINISHED CYCLE
OK
SCREEN B1-6
24
P2 ?
EXIT
P2 (3 s)
TYPE OF CYCLE
PHASE 2 CLEAN
SCREEN B1-2
TYPE OF CYCLE
PHASE 5 BLEED
SCREEN B1-5
Prolonged pressing (3 seconds) of the button
of the machine to which the tool is connected
generates the message of video "J" (e.g.
Machine 2);
- it is possible to exit without changing the
setting or you can confirm your choice with OK;
- If the change is confirmed, the LED of the
machine flashes to indicate the different setting
- Pressing the button of the modified machine
resets the settings
DD-MM-AA hh-mm
COMPLETE
DD-MM-AA hh-mm
COMPLETE
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
PHASE 3 BLEED
SCREEN B1-3
DD-MM-AA hh-mm
TYPE OF CYCLE
COMPLETE
PHASE 4 LUBRICATION
SCREEN B1-4