Orved Evox 25 Mode D'emploi Et D'entretien page 24

PREPARATION
6) When preparing liquid products, be careful not to fill the bag up to more than half of its total volume.
7) Close the machine lid.
6.2 VACUUM CONTAINER USE
1) Before using the machine for the first time, it's necessary to calibrate the vacuum sensor: in order to calibrate
the vacuum sensor to the atmospheric pressure level, at the first use and any time the machine is moved from a place
to another at a different altitude, it's necessary to operate the vacuum sensor calibration. Connect the machine, then
press the PUMP key for 5 seconds and close the lid. Wait until the end of the cycle.
2) Lid valves need to be open in order to allow vacuum creation inside the container: prepare a container or a vacuum
A
lid with the open valve
A
b
24
Rev. 02 - 05/2016 - Cod. 1500015 - Instruction manual for vacuum chamber packaging machines EVOX 25 / EVOX 25 H
b
, in order to allow vacuum creation inside the container.
A
b
b