Cleaning The Fine Dust Filter - Miele Boost CX1 Mode D'emploi

en-US
The flap will open and the dust will fall
out.
 If you need to clean the dust con-
tainer, use a slightly damp cloth and
mild liquid dish soap.
 Dry the dust container carefully.
 Close the flap firmly. It should click
into place.
 Insert the dry dust container back
into the vacuum cleaner at an angle
with the handle lifted up (Fig. 28).
 Latch the dust container into place by
pushing the handle back down.

Cleaning the fine dust filter

(Figs. 29–36)
The fine dust filter is located on the rear
side of the dust container. It is
equipped with a filter mat.
Clean the filter when necessary and
whenever you notice a reduction in suc-
tion power. Clean both filters with water
once a month and allow a drying time
of 24 hours.
 Remove the dust container (Fig. 26).
The fine dust filter is located at the rear
of the dust container.
 Remove the fine dust filter in the di-
rection of the arrow (Fig. 29).
 Remove the filter mat from the fine
dust filter (Fig. 30).
 Carefully knock the dust out of both
filters over a trash can.
 Take the cleaning tool out of the side
flap on the dust container (Fig. 31).
18
 Clean the pleated side of the fine
dust filter with the long brushes on
the cleaning tool (Fig. 32).

Risk of damage caused by incor-
rect cleaning.
The fine dust filter and the filter mat
can become damaged. Both filters
can lose their effect.
Do not use pointed or sharp-edged
objects to clean the fine dust filter
and the filter mat.
Clean the pleated side of the fine dust
filter and the filter mat with water once a
month.
 Rinse the pleated side of the fine dust
filter under cold running water
(Fig. 33).
 Clean the filter mat under cold run-
ning water (Fig. 34).

Risk of damage caused by incor-
rect cleaning.
The fine dust filter and the filter mat
can become damaged. Both filters
can lose their effect.
Do not use liquid dish soap or clean-
ing brushes when cleaning the
pleated side of the fine dust filter
with water. After cleaning, allow the
fine dust filter to dry in a well venti-
lated room for a minimum of
24 hours with the ribbed side facing
up. Choose a well ventilated room.
After cleaning, also allow the filter
mat to dry for a minimum of
24 hours.