Putting The Fine Dust Filter And The Filter Mat Together; Cleaning The Filter Frame And Pre-Filter - Miele Boost CX1 Mode D'emploi

 Clean the pleated side of the fine
dust filter with the long brushes on
the cleaning tool (Fig. 32).

Risk of damage caused by
incorrect cleaning.
The fine dust filter and the filter mat
can become damaged. Both filters
can lose their effect.
Do not use pointed or sharp-edged
objects to clean the fine dust filter
and the filter mat.
Clean the pleated side of the fine dust
filter and the filter mat with water once a
month.
 Rinse the pleated side of the fine dust
filter under cold running water (Fig.
33).
 Clean the filter mat under cold
running water (Fig. 34).

Risk of damage caused by
incorrect cleaning.
The fine dust filter and the filter mat
can become damaged. Both filters
can lose their effect.
Do not use dish detergent or
cleaning brushes when cleaning the
pleated side of the fine dust filter
with water. After cleaning, allow the
fine dust filter to dry in a well
ventilated room for a minimum of
24 hours with the pleated side facing
up. Choose a well ventilated room.
After cleaning, also allow the filter
mat to dry for a minimum of
24 hours.
Putting the fine dust filter and the
filter mat together
 Attach the dry filter mat to the dry fine
dust filter so that the soft side of the
filter mat is pointing up and the loop
used to remove it is visible (Fig. 35).
 Fit the fine dust filter carefully in the
dust container (Fig. 36).
 Press the fine dust filter firmly into
position.
In order to continue to achieve the
best possible cleaning results replace
the CX FSF fine dust filter with a new
one after approx. 3 years.
 Reinsert the dust container in the
vacuum cleaner (Fig. 28).
Cleaning the filter frame and pre-
filter (Figs. 37–41)
There is a removable filter frame on the
rear side of the dust container side flap.
Behind the side flap is a pre-filter.
Clean both parts whenever necessary.
 Remove the dust container (Fig. 26).
 Lift up the dust container handle and
hold it in this position (Fig. 37).
 Press the release catch on the side
flap. There is a cut-out on the
opposite side to make it easier to
remove the side flap.
 Remove the side flap.
Once the side flap has been removed,
the pre-filter inside can be accessed.
 Clean the pre-filter and the side walls
on the inside using the cleaning tool
(Fig. 38).
en-CA
41