Cleaning The Dust Container; Cleaning The Filter Frame; Cleaning The Fine Dust Filter; Starting The Comfortclean Self-Cleaning Function Manually - Miele SKCE0 Mode D'emploi

The contents of the dust container can
be disposed of with the normal house-
hold trash, providing it contains gen-
eral household dust only.
 Hold the dust container close to the
bin so that as little dust billows out as
possible.
 Press the yellow release button on
the bottom of the dust container.
The flap will open and the dust will fall
out.
 Close the flap so that it clicks audibly.
 Insert the dust container down into
the vacuum cleaner so that it audibly
clicks into place.
 Push the handle down.

Cleaning the dust container

Clean the dust container as required.
 Clean the dust container using water
and liquid dish soap.
 Dry the dust container carefully.
Cleaning the filter
frame (Figs. 24 + 25)
A removable filter frame is located in the
dust container. This should be cleaned
if it is obviously dirty.
 Place the emptied and open dust
container on its front.
 Release the filter frame and remove it.
 Empty the filter frame and rinse it un-
der cold running water.

Do not use detergent!
Do not use any sharp or pointed ob-
jects!
Dry the filter frame carefully!
 Place the dry filter frame in the dust
container so that it audibly clicks into
place.

Cleaning the fine dust filter

The fine dust filter is equipped with a
self-cleaning function. When a specified
degree of soiling is reached, the vac-
uum cleaner switches off automatically
for approx. 20 seconds and carries out
a cleaning process. You will hear this
process running.
The ComfortClean button on the vac-
uum cleaner lights up yellow.
Starting the ComfortClean self-clean-
ing function manually (Fig. 26)
If a large amount of dust has been vac-
uumed at once, the ComfortClean self-
cleaning function should be started
manually either during a vacuuming
pause or immediately afterward. This
enables the vacuum cleaner to achieve
the very best cleaning performance
again right away.
 With the vacuum cleaner switched
on, press the ComfortClean button
for at least two seconds.
The vacuum cleaner is switched off au-
tomatically for approx. 20 seconds and
a cleaning process is carried out which
results in operational noise.
The ComfortClean button on the vac-
uum cleaner lights up yellow.
The vacuum cleaner will then switch
back on automatically and will operate
with the previously selected setting.
en-US
17