Frequently Asked Questions - Miele SKCE0 Mode D'emploi

Frequently Asked Questions

With the help of the following guide minor faults in the performance of the ma-
chine, some of which may result from incorrect operation, can be remedied with-
out contacting the Service Department. Time and money will be saved because a
service call will not be needed.
This guide may help you to find the reason for the fault, and how to correct it.
Problem
The vacuum cleaner
turns off automatically.
The ComfortClean but-
ton lights up in yellow.
The ComfortClean but-
ton lights up in red.
The vacuum cleaner
switches itself to the
lowest power setting.
Cleaning power is re-
duced.
Possible cause and solution
A temperature limiter switches the vacuum cleaner off
automatically when it gets too hot. This can occur
when the airways are blocked by bulky objects.
 Turn the vacuum cleaner off immediately using the
On/Off foot switch , and unplug it.
After removing the cause, wait for approximately 20 -
30 minutes to allow the vacuum cleaner to cool down.
It can then be turned on again.
The vacuum cleaner carries out an automatic cleaning
process which you can hear running.
 Wait for approx. 20 seconds until this cleaning
process has finished.
The dust container is full.
 Empty the dust container.
The pre-filter is dirty.
 Clean the pre-filter (see "Frequently asked ques-
tions - Cleaning the pre-filter").
The fine dust filter is dirty.
 Clean the fine dust filter at the next available op-
portunity (see "Frequently asked questions -
Cleaning the fine dust filter manually").
The pre-filter is dirty.
 Clean the pre-filter (see "Frequently asked ques-
tions - Cleaning the pre-filter").
The fine dust container is full.
 Empty and clean the fine dust container at the
next available opportunity (see "Frequently asked
questions - Cleaning the fine dust filter manually").
en-US
19