Cleaning The Dust Container; Cleaning The Filter Frame; Cleaning The Fine Dust Filter; Starting The Comfortclean Self-Cleaning Function Manually - Miele HS16 Mode D'emploi

 Lift the dust container upwards to re-
move it.
The contents of the container can be
disposed of with normal household
waste, providing they consist of gen-
eral household dust only.
 Hold the dust container close to the
bin to prevent dust from billowing out.
 Press the yellow release catch on the
bottom of the dust container.
The flap will open and the dust will fall
out.
 Close the flap so that it audibly clicks
into place.
 Insert the dust container into the va-
cuum cleaner from above so that it
audibly clicks into place.
 Push the handle down.

Cleaning the dust container

Clean the dust container as required.
 Clean the dust container using water
and mild washing-up liquid.
 Dry the dust container thoroughly.
Cleaning the filter frame (dia. 25 + 26)
A removable filter frame is located in the
dust container. This should be cleaned
if it is obviously dirty.
 Place the emptied and open dust
container on its front.
 Release the filter frame and remove it.
 Empty the filter frame and rinse it un-
der cold running water.

Do not use washing-up liquid!
Do not use any sharp or pointed ob-
jects!
Dry the filter frame carefully!
 Replace the dry filter frame in the
dust container so that it audibly clicks
into place.

Cleaning the fine dust filter

The fine dust filter is equipped with a
self-cleaning function. When a specified
degree of soiling is reached, the va-
cuum cleaner switches off automatically
for approx. 20 seconds and carries out
a cleaning process. You will hear this
process running.
The ComfortClean button on the va-
cuum cleaner lights up yellow.
Starting the ComfortClean self-clean-
ing function manually (dia. 27)
If a large amount of dust has been va-
cuumed at once, the ComfortClean
self-cleaning function should be started
manually either during a vacuuming
pause or immediately afterwards. This
enables the vacuum cleaner to achieve
the very best cleaning performance
again straight away.
 With the vacuum cleaner switched
on, press the ComfortClean button
for at least two seconds.
The vacuum cleaner is switched off
automatically for approx. 20 seconds
and a cleaning process is carried out
which results in operational noise.
The ComfortClean button on the va-
cuum cleaner lights up yellow.
The vacuum cleaner will then switch
back on automatically and will operate
with the previously selected setting.
en
39