Maintenance; Emptying And Cleaning The Dust Container; Cleaning The Fine Dust Filter - Miele Boost CX1 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

en-CA

Maintenance

Risk of electric shock from
voltage.
The supply voltage is applied to the
appliance even if it is switched off.
Before carrying out any maintenance
work, unplug the appliance from the
electrical socket.
It is recommended to use only genuine
Miele accessories bearing the
"ORIGINAL Miele" logo on the
packaging. Only these will guarantee
the optimum performance of your
vacuum cleaner and the best possible
cleaning results.
Please note that faults and damage
caused by use of accessories which
do not bear the "ORIGINAL Miele"
logo on the packaging are not covered
by the vacuum cleaner warranty.
Emptying and cleaning the dust
container (Figs. 25–28)
 Empty the dust container before the
dust has reached the max marking
on the dust container (Fig. 25).
 Unlatch the dust container by lifting
the handle up (Fig. 26).
 Remove the dust container.
The contents of the dust container can
be disposed of with normal household
trash, providing it contains general
household dust only.
 Hold the dust container close to the
trash can so that as little dust billows
out as possible.
40
 Press the release catch on the
bottom of the dust container (Fig. 27).
The flap will open and the dust will fall
out.
 If you need to clean the dust
container, use a slightly damp cloth
and mild dish detergent.
 Dry the dust container carefully.
 Close the flap making sure it clicks
into place.
 Insert the dry dust container back
into the vacuum cleaner at an angle
with the handle lifted up (Fig. 28).
 Latch the dust container into place by
pushing the handle back down.

Cleaning the fine dust filter

(Figs. 29–36)
The fine dust filter is located on the rear
side of the dust container. It is
equipped with a filter mat.
Clean the filter when necessary and
whenever you notice a reduction in
suction power. Clean both filters with
water once a month and allow a drying
time of 24 hours.
 Remove the dust container (Fig. 26).
The fine dust filter is located at the rear
of the dust container.
 Remove the fine dust filter in the
direction of the arrow (Fig. 29).
 Remove the filter mat from the fine
dust filter (Fig. 30).
 Carefully knock the dust out of both
filters over a trash can.
 Take the cleaning tool out of the side
flap on the dust container (Fig. 31).

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Boost cx1 cat & dog powerlineBoost cx1 parquet powerlineBoost cx1 powerlineBoost cx1 cat & dogSnrf0Sncf0

Table des Matières