Replacing The Thread Lifters; Maintenance - Miele Boost CX1 Mode D'emploi

 Place the insertion aids that are
located on both sides of the new
exhaust filter into the guides on the
exhaust filter compartment (Fig. 43).
 Push the exhaust filter back and up.
 Press the exhaust filter firmly into
position until it clicks into place.
 If you have fitted your vacuum
cleaner with a HEPA AirClean exhaust
filter, press the TimeStrip® filter
change indicator (Fig. 09).
After approx. 10–15 seconds a thin red
line will appear in the left-hand side of
the display (Fig. 10).
 Fit the exhaust filter compartment
flap carefully in the bottom of the
exhaust filter compartment and close
the flap, making sure it clicks into
position (Fig. 11).
Replacing the thread lifters (Fig. 44)
(not possible on models with
EcoTeQ Plus floorhead)
The thread lifters on the suction inlet to
the floorhead can be replaced. Replace
the thread lifters if the pile has worn
down.
 Lift the thread lifters out of the slots.
To do so use a suitable tool, e.g., a
flat-head screwdriver.
 Install new thread lifters.
Replacement parts are available from
your Miele dealer or through Miele
Service.

Maintenance


Risk of electric shock from
voltage.
The supply voltage is applied to the
appliance even if it is switched off.
Before cleaning, unplug the
appliance from the electrical socket.
Vacuum cleaner and accessories

Risk of electric shock from
voltage.
If moisture gets into the vacuum
cleaner, there is a risk of electric
shock.
Do not let the vacuum cleaner get
wet.
Follow the special cleaning
instructions for the fine dust filter and
the filter mat (see "Maintenance" –
"Cleaning the fine dust filter").
The vacuum cleaner and all plastic
accessories can be cleaned with a
commercially available cleaner suitable
for plastic.

Damage due to unsuitable
cleaning agents.
All surfaces are susceptible to
scratching. Contact with unsuitable
cleaning agents can alter or
discolour the external surfaces.
Do not use abrasive cleaning agents,
glass cleaning agents, all-purpose
cleaners, or oil-based conditioning
agents.
en-CA
43