Change Language; External Alarm - Abus Terxon MX Instructions D'installation

125 No signal „closed"
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 125:Omit > 1 OFF
UK
3. Via the keypad, select from the following items
and press:
0
1
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.

126 Change language

To change the language used for the control unit display:
1. On the control unit, enter:
2. The LCD display shows: 126:Lang=English
3. Via the keypad, select from the following items
and press:
00
01
02
03
04
05
06
07
08
09
4. Confirm your input. On the control unit, enter:
.
125
Omit >1 OFF
Omit >1 ON
The alarm centre does not transmit the
„closed" signal if more than 1 zone is
locked.
(Function only with Scancom Fast
Format)
126
ENGLISH
ITALIAN
ESPANOL
PORT
NEDERL
FRANCAI
GERMAN
NORW.
SWED.
DANSK
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.

128 External alarm

All radio transmitters are monitored via the radio
expansion unit. If a radio zone has not communicated with
the radio expansion unit for more than 2 hours then this
reports a monitoring error. The external alarm function
describes how the alarm centre reacts to this fault. To
change the settings:
1. On the control unit, enter:
2. The LCD display shows: 128:Full Alarm
3. Via the keypad, select from the following items
and press:
Full Alarm
0
Sirens + call to central station
Local Alarm
1
Internal, external + control unit tone
2 Keypads only
Comms only
3
Inhibit Set
Control unit tone; the alarm centre can
4
not be activated until the faulty detector
reacts
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
76
128