Abus Terxon MX Instructions D'installation page 178

UK
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
114 Call back mode
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 114:Callback OFF
3. Via the keypad, select from the following items
and press:
0
1
2
4. Confirm your input. On the control unit, enter:
.
The alarm centre interprets a call as a
message from a remote PC. 10 to 90
seconds later, the remote PC calls
again once and the alarm centre
answers immediately on the first call.
(Set command 112 to a larger number
of calls than other end devices on the
line)
114
CallBack OFF
(the call to the remote PC must be
triggered manually – command 0 user
mode).
CallBack ON
The alarm centre answers after the set
number of calls. The alarm centre
hangs up and checks the ID and
software version of the remote PC.
After a short delay time, the alarm
centre calls back the PC (see command
118+119).
CallBack ANY
When deactivated, the alarm centre
answers after a set number of calls
(command 112+113) and accepts the
programming commands immediately.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
115 Telephone number 1
To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 115:Tel No 1
3. Via the keypad, enter the telephone number.
A
Use key to enter a 4-second pause (shown by a
comma).
u
4. Confirm your input. On the control unit, enter:
.
5. The control unit acknowledges your input with a
double "beep" tone and shows Installer mode.
116 Telephone number 2
See command 115.
117 Client no. CS
With SIA formats the control unit can report alarms using
a six-digit account code. Account code 1234 becomes
001234. To change the settings:
1. On the control unit, enter:
2. The LCD display shows: 117:Account No
3. Use the keyboard to enter the numbers of the
client no. („account no") for partition A.
C D
Keys and
left.
u
4. Confirm your input. On the control unit, enter:
.
5. Repeat step 3 for the additional partitions.
6. The control unit acknowledges your input with a
double "beep" tone and shows Installer Mode.
Some European countries use letters in the account
number. The alarm centre accepts the letters B, C, D, E
and F. To enters letters, use the keyboard the same way
as when assigning the zone names.
74
115
117
move the cursor to the right and