Switching Off Fin Sauna Mode; Starting Combined Hum Mode; Switching Off Combined Hum Mode - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Installation instructions, only for experts
9.7. Switching off
Briefly press the On/Off button
► The sauna heater switches off.
► The standby indicator lamp
► The light (cleaning light) is on.
To switch off the controller, briefly press the On/Off button
► The standby indicator lamp
9.8. Starting combined
Select HUM mode. Briefly press the On/Off button
► The controller starts with the settings that were most recently used for
this operating mode.
► The standby
Select the preferred temperature using the Minus
► The display
onds, after which the measured temperature (actual value) is displayed.
Press the Mode button
Select the preferred humidity using the Minus
see "Fig. 1: Characteristic curve showing humidity relative to temperature" on
page 11)
► The display
If a humidity sensor (optional) is installed, the measured humidity
(actual value) is displayed after a few seconds.
9.9. Switching off combined
Briefly press the On/Off button
► The sauna heater and the evaporator are switched off.
► The standby indicator lamp
► The light (cleaning light) is on.
To switch off the controller, briefly press the On/Off button
► The standby indicator lamp
sauna mode
FIN
.
4
8
8
HUM
and temperature
8
shows the selected temperature (setpoint) for a few sec-
1
until the humidity indicator lamp
7
shows the selected humidity (setpoint).
1
.
4
8
8
flashes. The operating mode is now OFF
flashes = standby mode
mode
4
indicator lamps light up.
9
5
and Plus
5
mode
HUM
flashes. The operating mode is now OFF
flashes = standby mode
p. 28/38
.
4
.
and Plus buttons.
6
lights up.
3
buttons (< 70 °C
6
.
4