Installation instructions, only for experts
9.10. Stopping the post-drying programme
After combined mode, the post-drying programme is started automatically.
The display 1 shows the message "dry" and the humidity indicator lamp flash-
es. For the settings possible for the post-drying programme, see "Setting the
post-drying programme" on page 32
► Press the On/Off
3 seconds.
To prevent mould and rot from forming, the post-drying programme should
NOT be stopped.
9.11. Setting the timer
The timer can be set in minutes (0 to 99). An acoustic signal (buzzer in the power
unit) sounds after the time has elapsed.
Press the Mode button
preferred interval using the Minus
► The display
9.12. Dimming the light
The light in the sauna cabin can be dimmed. To do this, the controller must be
set to FIN or HUM mode.
Press the Mode button
► Select the preferred brightness of the cabin light by pressing and holding
the Minus
5
► If you briefly press the Plus button
imum (100).
► If you briefly press the Minus button
If the external light switch is switched on, the cabin light remains at full
brightness. If you wish to dim the light using the control unit, the external
light switch must be in the OFF position.
and Minus
4
until the timer indicator lamp
7
and Plus
5
shows the remaining time.
1
until the light indicator lamp
7
or Plus
buttons.
6
buttons simultaneously for around
5
a
buttons.
6
2
, the cabin light switches to max-
6
, the cabin light switches off (0).
5
p. 29/38
lights up. Select the
lights up.
EN