Switching On The Light (Cleaning Light); Selecting The Operating Mode; Starting Fin Sauna Mode - Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi

Installation instructions, only for experts

9.4. Switching on the light (cleaning light)

The light (cleaning light) in the sauna cabin can be switched on and off using an
external light switch in any operating mode.
The light (cleaning light) in the sauna cabin can be switched on and off by pressing
the On/Off button
4
mode for this). The light switches off automatically after 5 minutes.
► The standby indicator lamp
The light in the sauna cabin can be dimmed. To do this, the controller must be
set to FIN or HUM mode (see "9.12. Dimming the light" on page 29).

9.5. Selecting the operating mode

The following operating modes are available for selection:
• Sauna mode "FIN" (default)
• Combined mode "HUM"
• Cleaning light "OFF"
Press the On/Off button
and Plus buttons.
6
9.6. Starting
FIN
Select FIN mode. Then briefly press the On/Off button
► The controller starts with the settings that were most recently used for
this operating mode.
► The standby
Select the preferred temperature using the Minus
(< 110 °C)
► The display
onds, after which the measured temperature (actual value) is displayed.
on the control unit. (The controller must be set to standby
8
and select the operating mode using the Minus
4
sauna mode
and temperature
8
shows the selected temperature (setpoint) for a few sec-
1
flashes = standby mode
4
indicator lamps light up.
9
and Plus
5
p. 27/38
5
.
buttons
6
EN