Publicité
Les langues disponibles
Les langues disponibles
Specifications
Dead weight:
19.5 kg
Payload:
30 kg at 50 kg supporting load
40 kg at 60 kg supporting load
max. 55 kg at 75 kg supporting load
max. 60 kg at 90 kg supporting load
Material:
Steel
Electrical connection:
Tow bar requirements
• The trailer tow bar must be approved in its construction.
• Ball and ball rod must have been forged in one piece.
• Only mount the bicycle rack to a coupling of steel St52-3, grey cast iron GGG52 or higher quality.
• The D-value of the tow bar ball must be at least 7.6 kN
• Never mount the rack to a tow bar made of aluminium, other light metals or plastic.
Unsuitable ball rods made from GGG40 are produced by Westfalia for the following vehicles:
Manufacturer
Westfalia
Observe the instructions from the tow bar manufacturer. If in doubt, ask your manufacturer directly whether
their trailer tow bar is suitable.
Safety notes
Driving with a mounted bicycle rack will affect the driving characteristics of your vehicle.
•
Adjust your speed to the new driving characteristics.
•
Never drive faster than 130 km/h.
•
Avoid sudden or jerky steering movements.
•
Remember that your vehicle is longer than usual.
Personal injury or property damage due to loss of the bicycles.
Driving without safety straps can lead to accidents.
•
Before embarking on any journey, check the correct and firm seating of the strap around the bicycles
and U-bracket of the rack.
•
Before embarking on any journey check the correct and firm seating of both straps around the front
wheel and the strap around the rear wheel of the bicycle.
•
If necessary tighten the straps again.
•
Before embarking on any journey, check to make sure the straps used are undamaged and not worn.
•
Damaged or worn straps must be replaced with undamaged ones before you embark on your journey.
Only straps authorised by EAL GmbH for the purpose may be used.
Personal injury or property damages caused by protruding parts.
Parts protruding beyond the edge of the vehicle or rack may cause personal injury or property
damage during the journey.
•
Only mount parts that do not protrude beyond the edge of the vehicle.
Personal injury or property damage due to overloading.
Exceeding the maximum payload of the bicycle rack and the permitted supporting load of the trailer tow bar
or permitted overall weight may lead to serious accidents.
•
Always observe the specifications regarding the maximum payload, permitted supporting load and
permitted overall weight of your vehicle. Do not exceed these specifications at any time.
Property damage due to opening tailgate.
The tailgate could hit the bicycle rack and be damaged.
•
Switch off the electric tailgate and operate it manually.
•
Fold down the bicycle rack before opening the tailgate.
Property damage caused by hot exhaust gases.
Damages may be caused to the rack or bicycles if the exhaust outlet is close by.
•
Use an exhaust deflector if necessary.
•
Personal injury or property damage possible due to a damaged bicycle rack.
Damage to the rack, e.g. by bent parts, cracks or scratches, prevents the safe operation of the rack.
•
Do not mount the bicycle rack if it is damaged in any way.
13-pin connector
Test symbol
F 4192
F 3830
F 4112
Suitable for
Audi A4
Audi A6
Audi A8
Publicité
