Publicité
Les langues disponibles
Les langues disponibles
Mounting the short tensioning straps
8 x Tensioning strap, short
Insert the short tensioning strap from the inside to the outside below the bike
holder and then from the outside to the inside through the slots of the bike holder
(see picture).
Mounting the bicycle rack on the trailer tow bar
Ensure that the trailer tow bar is undamaged,
clean and free of grease.
Before you put the bicycle rack on the trailer tow
bar, familiarise yourself with the quick locking
system.
The quick locking mechanism is a component
with a lever. Activating the lever opens or closes
the quick locking mechanism. With the help of
the securing bolt and the padlock, the quick
locking system may be locked and secured.
The padlock must always be used as
additional security when using the
bicycle rack.
Park your vehicle on a level surface.
Apply the handbrake.
Remove the securing bolt from the quick locking mechanism and rotate by 90° to prevent it from engaging
again. Open the quick locking mechanism by lifting the lever.
Place the rack, from above, horizontally onto the trailer tow bar. Push the lever of the quick locking
mechanism down (force required is approximately 35 - -40 kg) as far as it will go (the lever will remain in the
horizontal position).
Check whether the bike rack is securely and firmly positioned on the trailer tow bar and can no longer be
rotated. If this is not the case, the quick locking mechanism must be readjusted. Lift the lever and remove the
rack from the trailer tow bar. Remove the protective cap of the adjusting screw. Undo the lock nut of the
adjusting screw and rotate the adjusting screw on the quick locking mechanism tighter by a quarter turn.
Then tighten the lock nut again.
Replace the rack back on the trailer tow bar and check whether the rack is securely and firmly positioned on
the tow bar. Repeat the adjustment process until the rack is secure and firm. Push the protective cap back
onto the adjustment screw.
Caution: Always make sure that the lock nut on the adjusting screw is correctly tightened!
Slight signs of pressure on the two bar ball are normal and do not influence the
functionality.
When the rack can no longer be rotated on the trailer tow bar, rotate the securing bolt of the quick locking
mechanism until it engages. Now close the quick locking mechanism with the supplied padlock and remove
the key from the lock. Store the key carefully and in a safe place. The bicycle rack is now secured to prevent
theft.
Regularly check the firm seating of the rack on the trailer tow bar as well as the attachment of the bicycles to
the rack. Also regularly check the functions of the lighting system of your bicycle rack.
Mounting the bicycles to the rack
4 x Tensioning strap, short
The first bicycle is placed in the first wheel rail (closest to the
vehicle) and secured to the U-bracket with the short frame holder. To
do this, use the side of the frame holder with the tensioning strap to
secure to the bicycle frame. The wheels are secured by placing the
tensioning straps around the wheel rim of your bicycle and tightening
the straps. Caution: The front wheel must also be secured to prevent
it from turning using an additional small tensioning strap. To do this,
Safety/locking pin
Lock nut
Adjusting screw for
quick locking system
Lever
Lock
Publicité
