Publicité
Les langues disponibles
Les langues disponibles
•
Follow the steps as described in the chapter on "Maintenance".
Personal injury or property damage due to loss of the bicycle rack while driving.
A loose or faulty connection between the bicycle rack and trailer tow bar can lead to the detachment of
the bicycle rack.
•
Replace a defective trailer tow bar.
•
Clean the trailer tow bar of dirt, dust and grease.
Personal injury or property damage possible due to loss of bicycle parts while driving.
Damaged may be caused by parts that can be lost if they come away from the bicycle during the journey.
•
Remove all parts that may be lost before starting your journey, these include air pumps, batteries of
electric bikes, battery-powered lamps, navigation systems, bicycle computer, tool bags or baskets.
Personal injury or property damages caused by increase wind loads.
The bicycle rack and trailer tow bar may be damaged by too high a wind load.
•
Remove all bags from the bicycle before starting your journey.
•
Do not use protective covers for the bicycle during the journey.
The general operating permit must be carried in the vehicle when the rack is mounted.
Do not travel with the bicycle rack empty. Store it in the boot of your vehicle. This prevents
increased fuel consumption and protects the rack.
The driver is always responsible for ensuring that the load and the load securing meet the
regulations.
Operating instructions
The bicycle rack must first be assembled. Take all of the components out of the packaging and set them out
clearly. Every stage is described and clearly shows which components are required for the assembly of the
rack.
Mounting the wheel rails on the base frame
1 x Base frame
8 x Wheel rails
Two wheel rails form a pair. Place four pairs of wheel rails, with the plastic shells on the outside, parallel on
the base frame so that the drilled holes in the rail match the holes in the base frame. Secure each wheel rail
to the base frame with the lock screws M6 x 50, 17.8 x 6.5 x 1.1 washers and self-tapping nuts M6.
Mounting the lamp mounts
1 x Lamp mounting set
Join the two halves of the lamp mount set together. This is made easier by the small guide element which is
already mounted on one side. Push the rails together and secure the connection with the cross-headed
screw (M5x12), spring washer
washer 9.8 x 5.4 x 0.9.
Securing the light mount to the base frame
Insert the cross-headed screws M5 x 35 with spring washers and washers, from below, through the
vertical drilled holes of the lamp mount. Insert the screws through the threaded holes on the
underside at the end of the lamp mount. Tighten the screws.
2 x Cross-headed screw M5 x 35
2 x Spring washer 8.1 x 5.5 x 1.2
2 x Washer 9.7 x 5.3 x 0.9
16 x Lock screw M6 x 50
16 x Washer 17.8 x 6.5 x 1.1
16 x Nut M6
Cross-headed screw M5 x 12
Publicité
