Publicité
Les langues disponibles
Les langues disponibles
Mounting the U-bracket
1 x U-bracket
2 x Knob nut M8
2 x Washer 15.8 x 8.5 x 1.1
2 x Lock screw M8 x
Now fit the U-bracket onto the intended pipe sleeves. Push the lock screws M8 x 60 from the outside,
through the drilled holes of the U-bracket and the pipe sleeves. Place the washers and knob nuts M8 on the
ends of the screws and tighten the knob nuts firmly.
Mounting the frame holder
1 x Frame holder, wheel-to-wheel
1 x Frame holder, long
2 x Frame holder, short
Undo the handle screw of the frame holder and rotate out fully. Open the cuff of the frame holder and place
the inserts around the U-bracket at a position suitable for your bicycle. Place the cuff around the inserts and
push firmly together. Close the frame holder using the handle screw (but do not tighten).
The wheel-to-wheel frame holder is only required when you secure a fourth bicycle to the rack.
Mounting the license plate holder
1 x License plate holder
Remove the screws from the lamp mount of the license plate holder before mounting. Insert the screws
through the vertical slots of the license plate holder (see picture). Start the screws at the threaded holes of
the lamp mount, but do not tighten yet. Align the license plate folder so that it is at the same height as the
rear lights. Now tighten the screws.
Inserting the license plate
The mounting clips for securing the license plate are push-out
parts in the holder. Break out two of the clips. Slide the license
plate into the holder, then push the clips into the cut-outs to
secure the license plate.
Laying electrical cables
Lay the cables along the tube of the base frame. The cables may not be bent, stretched
or crushed, e.g. in the vicinity of the folding mechanism. Secure the cables with the
supplied cable ties. When you are finished, trim any excess material from the cable ties
using cutting pliers.
Attaching the plastic covers
4 x Plastic cover
Fit the plastic covers onto the middle of the wheel rails.
Clips
Cut-outs
Publicité
