Placing The Oven Into The Cabinet Opening - Thermador MASTERPIECE Serie Instructions D'installation

Masquer les pouces Voir aussi pour MASTERPIECE Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Lift the door up and pull out at an upward angle as
9.
shown in the following illustration. The notch in the
hinge foot will disengage from the oven door frame.
With both door hinge feet disengaged, lift the door off
the unit.
Carefully move the door to a safe place to protect it
10.
from damage until you are ready to reinstall it.

Placing the Oven into the Cabinet Opening

CAUTION
9
To avoid potential damage to flooring keep the
unit on its base packaging until immediately
before placing the unit directly into the cabinet
opening. Do not allow the metal base of the unit
to contact the flooring. See the following handling
instructions for details.
To avoid damage to the door (and/or warming
drawer front for combo units) do not lift, pull or
push the unit during installation by using the oven
door handle or warming drawer handle as a
gripping point.
Wear gloves and long sleeves to protect hands
and forearms from abrasion and potential
scratches during the lifting process. Take off
watches and jewelry and wear work shoes during
installation for foot protection.
When lifting the unit into place avoid grasping the upper
element to avoid damaging it. See the following
illustration for the correct lifting point.
The unit and its bottom packaging (pallet) should be
1.
positioned close to and in front of the cabinet opening
prior to beginning to lift the unit into place.
Lift or slide unit into the cabinet cutout without allowing
2.
the unit base to contact the flooring.
Guide the unit straight back into the cabinet cutout.
3.
Push the unit straight in until the oven trim is about
2 inches from being flush with cabinet wall. Be careful
not to crimp the flexible conduit between the oven and
the cabinet back wall. If necessary, guide the flexible
conduit into the wall or cabinet access hole so it
doesn't prevent the unit from being pushed all the way
into the cabinet opening. The oven should be straight
and level, not crooked.
11

Publicité

Table des Matières
loading

Table des Matières