Connecting The Microwave To The Lower Oven; Microwave Models; Customer Service - Thermador Masterpiece Serie Notice D'installation

Masquer les pouces Voir aussi pour Masterpiece Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Snap the conduit connector into the hole by pressing it
in until it clicks into place.
5. Follow the wiring diagram label (see image below) and
match and connect each wire by color to the wires
attached to the wiring block inside the oven-mounted
junction box. Push the bare end of the wire until it is
snug in the wiring block then tighten down the retaining
screw on each wire.
Tighten securely, but do not overtighten.
See previous illustration in Step 3 for
finished appearance.
6. Replace the oven-mounted junction box cover and
tighten the two screws holding it in place.
Tighten securely, but do not overtignten.

Customer Service

The model number and the FD number of your appliance are found on the rating label. Make a note of these
numbers to save time in the event further customer service is needed. Consult your Use and Care Guide for the
specific label location.
To contact Customer Service:
US: 800-735-4328
Web: www.thermador.com/support
Parts & Accessories: www.thermador-eshop.com
Connecting the Microwave to the
Lower Oven
Note: When installing the combination unit, the
microwave power cord must be properly attached to
the 120V receptacle. This must be done prior to
supplying electrical power to the oven unit.
A WARNING
Check to be sure that no electrical power has
yet been supplied to the oven.

Microwave Models

MEM301WS
POM301W
Installation of the Microwave to
the Lower Oven
Plug the microwave power cord into the 120V
receptacle located on top of the lower oven.
(See illustration below.)
3

Publicité

Table des Matières
loading

Table des Matières