Removing The Oven Door From Bottom Hinge Conventional Ovens - Thermador ME301YP Mode D'emploi

Replacing a G9 base oven light with
round glass cover
Requirements
¡ "Refer to the oven light bulb chart for the oven light
specification of your oven." → Page 28
¡ "Follow the safety instructions on replacing a light bulb."
→ Page 28
Turn off the power to the oven at the main power supply
1.
(fuse or breaker box).
Remove the oven racks.
2.
Turn the glass cover counterclockwise to remove it
3.
Remove the old bulb by grasping and sliding the bulb
4.
straight back until the two prongs have cleared the ce-
ramic holder ⁠ .
Do not touch the glass of the new replacement bulb di-
5.
rectly as oil from your fingers may cause the bulb to fail
prematurely. Instead, grasp the replacement bulb with a
clean dry cloth. Locate the two prongs in the ceramic
holder, gently poking until the two prongs locate in the
ceramic socket ⁠ .
Press in to seat the bulb.
6.
Screw the glass cover back on.
7.
Turn on the circuit breaker.
8.
Removing the oven door from bottom
hinge conventional ovens
For ease of cleaning you can remove the oven door of bot-
tom hinge ovens.
WARNING
Risk of injury!
Failure to follow these instructions when removing the
oven door may lead to personal injury or product damage.
Make sure oven is cool and power to the oven has been
▶
turned off before removing the door.
a Failure to do so could result in electrical shock or
burns.
The oven door is heavy and parts of it are fragile. Use
▶
both hands to remove the oven door.
The door front is glass. Handle it carefully to avoid
▶
breakage.
Grasp only the side of the oven door. Do not grasp the
▶
handle.
a It may swing in your hand and cause damage or in-
jury.
a Failure to grasp the oven door firmly and properly
could result in personal injury or product damage.
To avoid injury from hinge bracket snapping closed, be
▶
sure both levers are securely in place before removing
the door.
Do not force the door open or closed.
▶
a The hinge could be damaged and cause damage or
injury.
Do not lay the removed door on sharp or pointed ob-
▶
jects as this could break the glass. Lay it on a flat,
smooth surface, positioned so that the door cannot fall
over.
Open the oven door to its fully open position.
1.
⁠ .
Flip levers on hinges toward you.
2.
If necessary, use a tool, such as a screwdriver, to gently
pry the upper part of the lever away from the housing.
Take care to avoid scratching the housing.
Bring both door hinge levers to their fullest down posi-
3.
tion. The left and right door hinges differ slightly but op-
erate in the same manner.
4.
CAUTION - Risk of injury! Follow the instructions
below to prevent the latch from slamming shut and
pinching or cutting your hand.
Close the oven door until it catches on the hinge stop
levers, locking the hinges at the proper angle for door
removal.
a The door will be open about 7" (18 cm) at the top.
Cleaning and maintenance en-us
29