Reinstalling The Oven Door - Thermador ME301YP Mode D'emploi

en-us Cleaning and maintenance
5.
CAUTION - Risk of injury! The door is heavy.
Do not grip the door by the handle.
▶
Use both hands to firmly grip it by the sides.
▶
Maintaining the door angle, lift the door straight up ap-
proximately 3/4" (2 cm) to unhook the hinges from the
slots and then pull it out towards you until the hinges
are clear of the oven housing.
Place the door in a convenient and stable location.
6.
Do not lay the door on its handle. This could cause
dents or scratches.

Reinstalling the oven door

Hold the door firmly in both hands. Grip it on either side,
1.
not by the handle.
Tilt the door back slightly towards you until it opens
2.
about 7" (18 cm) at the top.
Slide the hinges into the slots
3.
and lower the door straight down
The angle of the door may need to be adjusted slightly
to allow the hinges to engage properly and the door to
lower into place. The door should lower about
3/4" (2 cm) and stop. If it does not, the hinges have not
engaged properly and the door could fall if it is released.
Once both hinges are fully engaged, gently open the
4.
door until it is fully open.
30
as far as they will go
⁠ .
Push the levers on both the hinges up and forward until
5.
they are locked into the slot and flush with the front of
the oven body.
Close and open the door slowly to be sure it is correctly
6.
and securely in place.