Thermador ME301YP Mode D'emploi page 32

en-us Eliminating faults
Fault
Oven is not self-cleaning properly
Clock and timer are not working
properly
"E" and a number appears in dis-
play and control beeps
With a new oven there is a strong
odor when oven is turned on
Control does not react when a key
is touched
Warm air or steam escapes from
oven vent
Cooling fan runs even when the
oven is turned off
32
Cause
The oven is too hot to start self
clean
There is no power supply to the
appliance
An electronics fault has occured
This is normal with a new oven
and will disappear after a few uses
The control is wet or soiled
The buttons are not pressed cor-
rectly
It is normal to see or feel steam or
warm air escaping from the oven
vent
The cooling fan will continue to
run, even after the oven has been
turned off, until the oven has
cooled sufficiently
Troubleshooting
Allow the oven to cool before running self
1.
clean.
Always wipe out loose soils or heavy
2.
spillovers before running self clean.
If the oven is heavily soiled, set the maxi-
3.
mum self clean time.
Check circuit breaker or fuse box to your
1.
house.
Make sure there is proper electrical power to
2.
the oven.
Press any key to stop the beeping.
1.
Reset the oven if necessary.
2.
Call an authorized service provider.
3.
Operate the self clean mode to burn-off the
▶
smell more quickly.
Clean the control panel an wipe it dry.
▶
Press the center of the button.
1.
Use the flat part of your finger.
2.
CAUTION
Risk of fire!
The oven vents are important for air circu-
lation. Covering the oven vents will cause
the oven to overheat. Refer to the appli-
ance overview for the location of the oven
vents.
→ "Familiarizing yourself with your appli-
ance", Page 11
▶ Do not obstruct oven vents.
This is normal. There is no action required.
▶