Dimensions And Cabinet Requirements; Removing Packaging; Left Packaging Bracket Removal; Right Packaging Bracket Removal - Thermador MASTERPIECE Serie Instructions D'installation

Dimensions and Cabinet Requirements

Cabinet requirements vary depending on the model to be
installed. Please consult the "Cabinet Dimension
Requirements" section at the back of this installation
manual for the details pertaining to your particular model.
All models require:
¼" (6.4 mm) space between the side of the oven and
▯
an adjacent wall or cabinet door when installed at the
end of a cabinet run.
Installation of 2x4's extending front to back flush with
▯
the bottom and side of the opening to provide oven

Removing Packaging

NOTICE To prevent damage to your floor keep the unit in
its packaging base until ready to be placed in the cabinet
opening. Do not slide the unit across the flooring.
Different models use different packaging materials.
Actual brackets may look differently. Bracket remains in
packaging base.
Cut straps on outside of box.
1.
Remove cardboard box.
2.
Remove all top and side cardboard and Styrofoam
3.
braces.
Place oven in front of cabinets where it is to be
4.
installed.
Unscrew unit from Left and Right Brackets as show in
5.
"Left and Right Packaging Bracket Removal".
support. This supporting base must be well secured to
the floor/cabinet and must be level.
The electrical conduit box must be located above the
▯
unit to facilitate connecting and servicing the unit.
The cabinet base must be flat and capable of
▯
supporting the weight of your oven when in use (varies
by model up to 429 lbs. (195 kg)). See the
appropriate weight for your model in the "Cabinet
Dimension Requirements" section at the back of this
installation manual.

Left Packaging Bracket Removal

Right Packaging Bracket Removal

7