Dimensions For 27" Under-Counter Units - Thermador MASTERPIECE Serie Instructions D'installation

27" Combo Oven with Microwave and Warming Drawer
èç
 PP

 PP

 PP
ê
 PP

 PP
Wall Installation 27" Combo Oven with Microwave and
Warming Drawer:
ê
 PP
It is good practice, when oven is installed at the end of a
cabinet run, adjacent to a perpendicular wall or cabinet
door, to allow at least 1/4" space between the side of the
oven and the wall/door.
For oven support, install 2x4's extending front to back
flush with the bottom and the side of the opening. The
supporting base must be well secured to the floor/
cabinet and level.
NOTICES
The conduit box must be located above the unit to
▯
facilitate connecting and servicing.
The cabinet base must be flat and capable of
▯
supporting a weight of at least 369 lbs (167 kg).
ë
 PP
ç
 PP

 PP


 PP
 PP
ë
 PP

 PP
PLQ ë
PD[ 
   PP

Dimensions for 27" Under-Counter Units


 PP
ë
 PP
* Includes ¾" (19 mm) base plate. For single ovens
installed under a cabinet, the junction box should be
located to the right of the unit within reach of the power
cord.
It is good practice, when oven is installed at the end of a
cabinet run, adjacent to a perpendicular wall or cabinet
door, to allow at least 1/4" space between the side of the
oven and the wall/door.
For oven support, install 2x4's extending front to back
flush with the bottom and the side of the opening. The
supporting base must be well secured to the floor/
cabinet and level.
Notes
The cabinet base must be flat and capable of
▯
supporting a weight of at least 193 lbs (87 kg).
This Built-In Oven can be installed below any
▯
Thermador cook top as long as there is no contact
between the bottom of the cook top and the top of the
oven, except for the Thermador induction cook top,
where the gap must be at least 1 inch (see illustrations
following).
  PP
é  PP

 PP
ê
 PP
15