Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Drufosmart scan
9.6 Exceeding of entered heating/cooling times
After elapse of times adjusted regu-
larly (display position a/c) there will be
an acoustic signal. The exceeded time
9.7 Entering a wrong barcode
If a barcode is scanned that does not
correspond to the programming of the
Drufosmart scan, four acoustic warning
signals will be heard and the display will
show ERROR at position b.
40
will be blinking in the display as control
mechanism.
By scanning the correct barcode you
can proceed further, as described in
point 8.0.
10 Optional additional functions
10.1 Fabrication of cast form parts
With the K-7 insert it is possible to
thermoform up to 7 resin bases for
the crown and bridge technique at the
same time. Fix the single dies by means
of a flexible blocking out material (e.
g. Fillin) in the holes of the K-7 insert.
Remove the nub plate from the insert
bowl and replace it by the K-7 insert.
All further working steps as described
from point 7.1 on.
11. Care and maintenance
Generally disconnect the unit from
with a slightly humid sponge and a mild
mains supply before executing care
cleaning liquid. Water and cleaning li-
and maintenance.
quids must not get into the unit.
Ideally cleaning is to be effected dryly
The O-rings should be greased regularly
with a soft piece of cloth, if necessary
with silicone grease.
41
Publicité
Table des Matières
